免费毛片aaaaaaI5月丁香婷婷综合I欧美精品亚洲精品I欧美成人视I日韩大片免费观看I五月婷婷欧美I日韩电影完整版在线观看I午夜黄色一级片I九一网站在线观看I96超碰在线I91夫妻视频I日韩免费观看高清I567第二季I高清windows免费看安全区I九九看片I丝袜 亚洲 另类 欧美 重口I日本japan18xxxⅹhd乱Iwww黄

TR 214 Liquid Mold Release 

Liquid mold release is recommended for use on fully cured, well conditioned molds only. It is not recommended on new or reconditioned molds until at least eight or ten parts have been pulled using paste wax. It should not be used as a final coat over paste wax as the high solvent content is provided to remove wax and wax build up. Rapid settling of liquid waxes requires shaking well immediately before and during eacch use.

Directions: On clean surface apply a small amount with brush, spray, or cloth. Be sure entire area is covered. Allow to dry and brush or wipe off. Excellent on, nonskid, grained, or sand type finsihes. Repaet as required.

TR 214液體脫模

液體脫模建議僅用于完全固化、條件良好的模具。不建議在新的或翻新的模具上使用膏蠟拉出至少8或10個零件。它不應該用作膏蠟的*后一層，因為高溶劑含量是用來去除蠟和蠟積聚的。液體蠟的快速沉淀需要在每次使用前和使用過程中立即搖勻。

使用方法:在清潔的表面上，用刷子、噴霧或布涂抹少量本品。確保覆蓋整個區域。晾干后刷掉或擦掉。優良的表面，防滑，顆粒，或砂型飾面。按要求補藥。